First, principle of work
After turning over the hoisting mechanisms airborne to turn over the mold 90 degrees, drawing of patterns to lay aside the body together with the mold side bar in cuts on the header, the longitudinal cutter device leads oneself through the electrical machinery to walk, to lays aside in cuts on header's body to carry on walks cutting, cutting completes next walks to suspends the position. The across cutting installment leads through the electrical machinery oneself walks after the body central stop carries on level-like cutting again, transverse cutting vertical landing cutting to the rise repositions from the top downward to the reference.
Second, technical parameter
| Serial number |
Name |
Unit |
Target |
Note |
| 1 |
Productivity |
Ten thousand M3/years |
5-15 |
Annual production |
| 2 |
Embrionic body size |
M |
4×1.2×0.6 |
Only |
| 3 |
Cutting modulus |
mm |
5/10 |
Slitting/transverse cutting |
| 4 |
Cutting precision |
mm |
±3±1.5±1.5 |
Long, width, high |
| 5 |
Production cycle |
min/mold |
5 |
|
| 6 |
Cutting main engine quality |
t |
12 |
Slitting/transverse cutting/track |
| 7 |
Cutting main engine installed capacity |
kw |
11.4 |
Including hydraulic pressure station |
Third, main feature
1st, the type structure simplification is practical, is advantageous for the installment service;
2nd, after body turn over, stands erect causes the body width is 600mm, is 1200mm highly, causes the cutting steel wire use to be shorter, is not easy to pull, is not easy to drift, the cutting precision is high;
3rd, the longitudinal cutter device is walks (body to cut on header fixed) to complete longitudinal cutting. The level-like infeed set-up uses the chain drive to be able to maintain the transverse cutting fluctuation transmission is consistent, guarantee cutting precision;
4th, after body erectness, the both sides (600mm wide) may simultaneously complete the milling in body longitudinal cutting, cannot dispose the notch processing equipment in addition;
5th, this aircraft besides produces the artificial brick also to be possible to produce the plate, moreover makes six cutting to the body, therefore the product quality is not spread the molding oil and the mold distortion influence;
6th, the equipment simplicity of operator is convenient, this type cutting process (turn over, slitting, transverse cutting) complete separately in the different location, moreover cuts, walks the control in identical to install, therefore works obtains the simplification, the operation maintenance is convenient.
JQF4.0M (JQF4.2M) step by step the stationary horizontal cutter principle of work see also the JQF6.0M step by step stationary type horizontal cutter.
|
